Connecting Via Ethernet; Resetting Wifi Connection - G3D T-1000 Manual

GETTING STARTED
CONFIGURING THE WIFI CONNECTIONS
5. Printer will shutdown after you press the join button.
6. Push the power button to turn on the printer.
7. Connect the device to home wifi where printer is also connected.
8. Press <x> button to close the browser.
9. Open the browser. If you haven't changed the hostname configuration,
type <g3dprint:8080> in the url box and press enter to access the Web UI.
g3dprint:8080

CONNECTING VIA ETHERNET

Once you join your home wifi you can use ethernet or use ethernet only.
1. Plug the ethernet cable into the ethernet port to connect to your device.
2. Open the browser. If you haven't changed the hostname configuration,
type <g3dprint:8080> in the url box and press enter to access the Web UI.

RESETTING WIFI CONNECTION

Once you are connected to your home WIFI. The only way to re-connect to
G3D or Printer Wifi is to push manually the printer's reset wifi switch located at
the left panel of printer. Use a small pin to push the wifi reset.
T-1000
ETHERNET
PORT
16