Version Number; Running Time Meter; System Parameters: Gateway; System Parameters: Data Set Transfer - Omron NT4S Operation Manual

Standard Mode

4.12.9 System Parameters: Gateway

4.12.10 System Parameters: Data Set Transfer

4.12.11 System Parameters: Parallel Outputs

4.13

Version Number

4.14

Running Time Meter

Setting of the gateway parameters applies only to operating terminals that have
been fitted with the corresponding firmware.
Parameters that can be defined for these operating terminals are:
- Smallest possible slave number
- Largest possible slave number
- Polling time for text list
- Cache size
- Polling time for cache
- Variable for cache address
- Variable for network status address
The following parameters are required to transfer data sets from the terminal to the
controller:
- Variable for recipe number
- Variable for data set number
The following parameters are required to transfer data sets from the controller (on
request):
- Variable for recipe number
- Variable for data set number
System parameters for the parallel outputs are the symbolic name of the variable
and the polling time of this variable. Every output can be enabled separately.
The version number is reserved for the user. Valid values range from 0 to 255. The
value is stored in a system variable. This system variable can be displayed by the
user in any I/O mask.
This variable has no further function in the operating terminal. Online editing of the
version number is not possible.
All operating terminals provide 8 running time meters to the user. In the program-
ming software, enter a variable name for the control byte which constitutes the
address at which the controller can influence the running time meters.
Every bit of this control byte represents one running time meter. If a bit is set to
logical 1, the corresponding running time meter is incremented in accordance with
the selected polling time cycle.
Section 4-14
161