Error Statistics Ser1 - Omron NT4S Operation Manual

Standard Mode
4.6.3.3

Error Statistics SER1

ComTimeout
Specifies the monitoring period for SER1. The value (0) deactivates the timeout
monitoring function.
Data type:
Editor:
Output:
Possible values:
ComRetryTimeout
Specifies the period of time, in milliseconds, that the terminal allows to elapse after
an attempt to establish a connection via SER1 failed, before making another at-
tempt. This allows the time period required for the PLC-specific powerup phase to
be bridged, thereby avoiding the generation of an error message.
Data type:
Editor:
Output:
Possible values:
ComSlaveNr
Contains the slave number used for the device on the network. This address
can be used to address the operating terminal on the bus.
Data type:
Editor:
Output:
Possible values:
ComParityCount
Error counter for monitoring of parity errors on SER1 to the PLC. Is erased on every
download.
Data type:
Editor:
Output:
Possible values:
ComOverrunCount
Error counter for monitoring of overrun errors on SER1 to the PLC. Is erased on
every download.
Data type:
Editor:
Output:
Possible values:
Numeric
Positive decimal number
---
(0) Inactive Initial state
(1 to 65535) Timeout monitoring active (time in
ms)
Numeric
Positive decimal number
---
0 to 65535 ms
Numeric
Positive decimal number
Positive decimal number
0 to 255
Numeric
(Possible)
Positive decimal number
0 to 65535
Numeric
(Possible)
Positive decimal number
0 to 65535
Section 4-6
89