Omron NT4S Operation Manual page 125

Standard Mode
StartUpload
This variable can be used to read, for the active recipe, a data set from the controller
and to store it in the terminal.
Data type:
Editor:
Output:
Possible values:
UploadDSNr
This variable specifies the data set number to which the uploaded data set is to be
written in the operating terminal.
Data type:
Editor:
Output:
Possible values:
UploadState
When uploading data sets to the operating terminal, this variable indicates the
upload status.
Data type:
Editor:
Output:
Possible values:
Numeric
Selection text
---
(0) Initial state
(1) Variables are read individually from their speci-
fied addresses
(2) Variables are read as a block from the buffer
specified for the recipe
(3) Variables are read individually from their speci-
fied addresses.
A free data set is automatically being searched
for.
If no free data set is available, system message
18 is displayed.
(4) Variables are read as a block from the buffer
specified for the recipe.
A free data set is automatically being searched
for.
If no free data set is available, system message
18 is displayed.
Numeric
Numeric
---
1 to 250
Numeric
---
Selection text
(0) Initial state
(1) Upload of data set in progress
Section 4-6
111