Omron NT4S Operation Manual page 100

Standard Mode
86
UserVersion
Indicates the version number of the project description to the operator. The user
enters this number into the programming system during programming time.
Data type:
Editor:
Output:
Possible values:
Boot
This variable can be used to initiate the terminal to boot (system restart). The vari-
able is suitable for integrating the setup function into the regular operator guidance,
making it possible to modify terminal parameters which require a subsequent rein-
itialization (system restart) in any I/O mask. The terminal is booted if a '1' is written
to this variable. Subsequently, the variable is automatically reset to '0'.
Data type:
Editor:
Output:
Possible values:
LCDContrast
Is used to adjust the contrast for terminals with liquid crystal displays.
Data type:
Editor:
Output:
Possible values:
LCDBackground
Is used to adjust the background of the display. This variable is only relevant for
operating terminals fitted with a corresponding display.
Data type:
Editor:
Output:
Possible values:
LCDBackLight
Is used to adjust the background lighting of the display. This variable is only rele-
vant for operating terminals fitted with a corresponding display.
Data type:
Editor:
Output:
Possible values:
Numeric
---
Numeric, 3 digits
---
Numeric
Selection text , positive decimal number
---
(0) Inactive Initial state
(1) Active System restart
Numeric
Integer
---
-127 to +127 (to be limited further based on terminal
type)
Numeric
Selection text , positive decimal number
---
(0) Normal representation
(1) Inverse background
Numeric
Any
---
(0) Background lighting OFF
(1 to x) Background lighting ON (dimmed)
Section 4-6