Table of Contents
Advertisement
Model W1701W (For Machines Mfd. Since 1/16)
Template.Shaping
The use of templates allows identical parts to be cut
with speed and accuracy. Shaping with a pattern begins
by attaching a prefabricated template to the rough
workpiece. The edge of the template rides against a rub
collar on the spindle as the cutter cuts the matching
profile on the workpiece edge, as shown in Figure.35.
Always perform test cuts on scrap stock to ensure pattern
works as required.
Template.Construction.Tips:
•
Use a material that will smoothly follow rub collar,
ball bearing, or fence.
•.
Make sure that screws or clamps will not come into
contact with the cutter.
•
Design the assembly so that cutting will occur
underneath the workpiece.
•
Make handles for safety and control.
•
Use materials that will move easily across the table
surface and rub collar.
•
Install hold-down clamps at three sides of the
pattern assembly or screw the pattern assembly to
the back side of the workpiece.
•
Remember, there are tremendous cutting forces
involved. Fixtures must be solid and stable, and any
workpiece must be firmly secured.
CUTTER.CONTACT.HAZARD!
Cutting. small. or. narrow. workpieces.
greatly. increases. the. risk. of. cutter.
contact. during. operation.. Use. jigs. or.
holding.devices.when.cutting.to.reduce.
this.risk.
Template
Workpiece
Figure.35..Profile of a template being
-29-
Rub Collar
used.
Advertisement
Table of Contents
