Shop fox W1701W Owner's Manual page 19

Model W1701W (For Machines Mfd. Since 1/16)
8. For custom fence facing, make sure the screw heads
are countersunk completely below the surface of the
fence face.
9. Insert the safety guard shaft into the work table
housing; tighten adjustment knob to lock guard shaft
in place (see.Figure.12).
10. Connect the safety guard bar to the safety guard
shaft with (2) M8-1.25 x 12 bolts and 8mm flat
washers (see.Figure.12).
11. Connect the safety guard to the safety guard bar
with (2) M4-.7 x 10 Phillips head screws and M4-.7
hex nuts (see.Figure.12).
12. Position the guard as close as possible to the
spindle/cutter without impeding the feeding path of
the workpiece, and tighten the safety guard shaft
knob.
13.. Place the 1
⁄ " table insert over spindle, then hold
3
8
an 8mm open-end wrench on the spindle flats (see
Figure.13).
14.. Use a 14mm open-end wrench to tighten the
drawbar nut, (see Figure.14), but DO.NOT over-
tighten it.
Note: This is an important safety measure that must
be done before the Test Run on the next page.
Safety
Guard
Work Table
Figure.12..Guard and fence assembly.
Spindle Flats
Figure.13..Wrench location on spindle.
Figure.14..Threading on drawbar nut with
the tapered end up.
-17-
Safety
Guard Bar
Housing
Safety Guard
Shaft
Table Insert
Taper