Set Vport (Ilmi) - Avaya Cajun P550R Cli Reference Manual

Chapter 1

set vport (ilmi)

Command Mode
Description
Syntax
Sample Output
1-128
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Configures Interim Local Management Interface (ILMI) address
registration on the VPORT. If add_reg is specified, the VPORT will
register the ATM address of the ATM Uplink module with the device
connected at the other end of the link in addition to getting an ATM
prefix and registering itself as an edge device under the UNI
connection.
* Note: You must disable a VPORT each time you make a change
to the configuration. After you make configuration
changes, you must enable the VPORT in order for the
changes to take effect.
set vport <interfaceID> <vpiNumber> ilmi 4.0
[{add_reg | no_add_reg}]
Table 1-78. Parameters, Keywords, Arguments
Name
interfaceID
vpiNumber
4.0 add_reg | 4.0
no_add_reg
This example sets the ILMI version for VPORT 1 5 to 4.0 Address
Registration.
ATM(configure)# set vport 1 5 disable
VPort 1 5 has been disabled
ATM(configure)# set vport 1 5 ilmi 4.0 add_reg
VPort 1 5 modified
ATM(configure)# set vport 1 5 enable
VPort 1 5 has been enabled
Definition
The ATM interface number. The range of
values is: Minimum = 1, Maximum = 2.
The VPI number. The range of values is:
Minimum = 0, Maximum = 255.
Sets whether or not to perform address
registration on the VPORT to:
• 4.0 Address Registration
• 4.0 No Address Registration
If omitted, the default is no_add_reg