Set Interface (Enable | Disable) - Avaya Cajun P550R Cli Reference Manual

Chapter 1

set interface (enable | disable)

Command Mode
Description
Syntax
Sample Output
1-26
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Enable or disable a physical interface to the ATM interface. Physical
port 1 is interfaceID 1 and physical port 2 is interfaceID 2.
* Note: You must disable an interface each time you make a
change to the configuration. After you make
configuration changes, you must enable the interface in
order for the interface to be operational.
set interface <interfaceID> {disable | enable |
medium-type | name}
Table 1-19. Parameters, Keywords, Arguments
Name
interfaceID
enable | disable |
medium-type |
name
This example shows interface 1 being disabled and enabled.
ATM(configure)# set interface 1 disable
Interface 1 has been disabled
ATM(configure)# set interface 1 enable
Interface 1 has been enabled
Definition
The ATM interface identification number. The
range of values is: Minimum = 1, Maximum =
2.
enable - Enables the ATM interface
disable - Disables the ATM interface
medium-type - options are SDH or SONET.
see "set interface (medium-type)" on page 27
name - set the ATM interface name. see
interface (name)" on page 28
"set