Chapter 1
set atm-link (enable | disable)
Command Mode
Description
Syntax
Sample Output
1-12
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Enable or disable an ATM link. Disabling an ATM Link effectively
blocks traffic to/from the remote destination. If you are using a
Replicating VSP, disabling a single ATM Link allows traffic to flow to
other destinations while blocking traffic from the disabled link's
destination.
You must also disable an ATM Link when you are going to make
changes to the link's parameters.
set atm-link <link-name> {enable | disable}
Table 1-9. Arguments, Parameters, Keywords
Name
link-name
enable | disable
The following example enables ATM Link TestLink:
ATM(configure)# set atm-link TestLink enable
ATM Link TestLink has been enabled!
Definition
The name of the ATM link you will enable or
disable.
Use th
e show atm-link <vsportId> [<link-
to get the name of an ATM-Link whose
id>]
name is greater than 10 characters.
Enables or disables the atm link.