Set Lec (Max-Bus-Cellrate-Value) - Avaya Cajun P550R Cli Reference Manual

set lec (max-bus-cellrate-value)

Command Mode
Description
Syntax
Sample Output
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Sets the maximum total number of cells the ATM Uplink module
will send per second to the BUS. This setting prevents the ATM
Uplink module from overloading the BUS. In the event there are
many flows that have not triggered separate DDVCCs, this setting
will ensure that all of the "micro" flows collectively don't overload
the BUS.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
set lec <lecID> max-bus-cellrate <max-bus-
cellrate-value>
Table 1-28. Parameters, Keywords, Arguments
Name
lecID
max-bus-cellrate-
value
This example sets the maximum number of cells per second sent to
the BUS for LEC 2 to 500cps.
ATM(configure)# set lec 2 disable
LEC 2 has been disabled
ATM(configure)# set lec 2 max-bus-cellrate 15
Maximum BUS Cellrate 500 has been set for LEC
2
ATM(configure)# set lec 2 enable
LEC 2 has been enabled
Avaya ATM Uplink Module CLI Commands
Definition
The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
The maximum number of cells per second to
sent to the BUS. The range of values is 0 to
1412830 for OC12, and 0 to 353207 for OC3
modules.
1-37