Set Lec (Proxy) - Avaya Cajun P550R Cli Reference Manual

set lec (proxy)

Command Mode
Description
Syntax
Sample Output
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Set the proxy mode for the LEC. The LEC can proxy for MAC
addresses that are local to the Avaya switch only; or for MAC
addresses learned from other LECs in addition to the local MAC
address. If proxying for all, the ATM Uplink module will work in
conjunction with another LEC to bridge between two ELANs. This is
not a recommended configuration since this implies a routing
function. See Appendix B of the ATM Uplink User's Guide for more
details.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
set lec <lecID> proxy { all | ethernet }
Table 1-32. Parameters, Keywords, Arguments
Name
lecID
all | ethernet
This example sets the proxy for LEC 1 to ethernet:
ATM(configure)# set lec 1 disable
LEC 1 has been disabled
ATM(configure)# set lec 1 proxy ethernet
Proxy ethernet has been set for LEC 1
ATM(configure)# set lec 1 enable
LEC 1 has been enabled
Avaya ATM Uplink Module CLI Commands
Definition
The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
Which MAC addresses you want the ATM
Uplink module to proxy for. Options include:
• all - LEC will proxy for local MAC
addresses as well as MAC addresses
learned from other LECs.
• ethernet (default)- LEC will only proxy
for local MAC addresses.
1-41