1
First Steps with the TNC 620
1.4
Graphically testing the first part
Starting the test run
Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the STOP soft key: The TNC interrupts the
test run
Press the START soft key: The TNC resumes the
test run after a break
Further information on this topic
Performing a test run
Further Information:
Graphic functions
Further Information:
Adjusting the simulation speed
Further Information:
page 549
66
Test run, page 559
Graphics (option 20), page 548
Speed of the setting test runs,
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015