HEIDENHAIN TNC 620 User Manual page 178

5
Programming: Tools
5.2 Tool data
Abbr. Inputs
LIFTOFF
Definition of whether the TNC should retract the tool in
the direction of the positive tool axis at an NC stop in
order to avoid leaving dwell marks on the contour. If Y
is defined, the TNC retracts the tool from the contour,
provided M148 has been activated.
Further Information:
contour at an NC stop: M148, page 389
TP_NO
Reference to the number of the touch probe in the touch-
probe table
T-ANGLE
Point angle of the tool. Is used by the Centering cycle
(Cycle 240) in order to calculate the centering depth from
the diameter entry
PITCH
Thread pitch of the tool. Used by tapping cycles (Cycle
206, Cycle 207 and Cycle 209). A positive algebraic sign
means a right-hand thread.
LAST_USE Date and time that the tool was last inserted via TOOL
CALL
PTYP
Tool type for evaluation in the pocket table
Function is defined by the machine manufacturer. The
machine documentation provides further information
ACC
Activate or deactivate active chatter control for the
respective tool (page 399).
Input
KINEMATIC Display tool carrier kinematics using the SELECT soft
key and confirm file name and path with the OK soft
key(in tool management, display using the GOTO key and
confirm with the SELECT soft key).
Further Information:
carriers, page 398
178
Automatically retract tool from the
range: N (inactive) and Y (active)
Allocate parameterized tool
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Dialog
Retraction permissible?
Yes=ENT/No=NOENT
Number of the touch probe
point angle
Tool thread pitch?
Date/time of last tool call
Tool type for pocket table?
ACC active?
Yes=ENT/No=NOENT
Tool-carrier kinematics