14
Datum management with the preset table 14.5
Editing the preset table
Soft key
Editing function in table mode
Select the table start
Select the table end
Select the previous page in the table
Select the next page in the table
Select the functions for entering presets
Display the "Basic Transformation/Axis Offset"
selection
Activate the datum of the selected line of the
preset table
Add the entered number of lines to the end of the
table (2nd soft-key row)
Copy the highlighted field (2nd soft-key row)
Insert the copied field (2nd soft-key row)
Reset the selected line: The TNC enters - in all
columns (2nd soft-key row)
Insert a single line at the end of the table (2nd
soft-key row)
Delete a single line at the end of the table (2nd
soft-key row)
501
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015