HEIDENHAIN TNC 620 User Manual page 213

Example – programming a straight line
Initiate the programming dialog, e.g. for a straight
line
COORDINATES?
Enter the coordinates of the straight-line end
point, e.g. -20 in X
COORDINATES?
Enter the coordinates of the straight-line end
Y
point, e.g. 30 in Y, and confirm with the ENT key
Radius comp.: RL/RR/no comp.?
Select the radius compensation (here, press
the R0 soft key—the tool moves without
compensation)
Feed rate F=? / F MAX = ENT
Enter 100 (feed rate e.g. 100 mm/min; for
programming in inches: enter 100 for a feed rate of
10 inches per minute) and confirm your entry with
ENT; or
Move at rapid traverse: Press the FMAX soft key;
or
Traverse at the feed rate defined in the
block: Press the F AUTO soft key.
CALL
MISCELLANEOUS FUNCTION M?
Enter 3 (miscellaneous function e.g. M3), and
terminate the dialog with the END key
The part program now contains the following line:
L X-20 Y+30 R0 FMAX M3
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Fundamentals of path functions
TOOL
6
6.2
213