HEIDENHAIN TNC 620 User Manual page 519

Displaying calibration values
The TNC saves the effective length and effective radius of the
touch probe in the tool table. The TNC saves the ball tip center
offset in the touch probe table, in the CAL_OF1 (principal axis) and
CAL_OF2 (minor axis) columns. You can display the values on the
screen by pressing the TOUCH PROBE TABLE soft key.
During calibration, the TNC automatically creates the
TCHPRMAN.html log file to which the calibration values are saved.
Please make sure the correct tool number is active
when you use the touch probe system. Regardless
of whether you want to use a touch probe cycle in
automatic mode or Manual operation mode.
For more information about the touch probe table,
refer to the Cycle Programming User's Manual.
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2015
Calibrating a 3-D touch trigger probe
14
14.8
519