Related Manuals for First Alert SFA600
Summary of Contents for First Alert SFA600
-
Page 1: User Manual
Wireless Driveway and Intruder Alert USER MANUAL SFA600 PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE. -
Page 2: Compliance With Fcc Regulations
COMPLIANCE WITH FCC REGULATIONS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation. -
Page 3: Location Of Controls
LOCATION OF CONTROLS 1. SOUND VOLUME 2. DC JACK 3. FUNCTION SELECTOR GETTING STARTED 1. Remove the screws at the back of the Sensor unit and Receiver unit, and open the battery doors.(Fig.1) 2. Install an alkaline 9V batteries (not included) for Sensor, 3x1.5 "C-size" batteries for receiver to the battery compartment make sure install with correct polarity. - Page 4 3. Hang the Sensor at the entrance of your driveway (such as on a mailbox, on a tree or or a ground stake). You may also place the PIR sensor on your garage, near the front entrance or rear door. Any movement nearby will let the PIR transmit a signal to the receiver chime unit triggering it to sound.(Fig.3) 4.
- Page 5 INTERNATIONAL, INC., official licensee for this product. All right, title and interest to use the “First Alert” logo trademarks and the “First Alert” trade dress are exclusively licensed by BRK Brands, Inc. and are used under license from BRK Brands, Inc.. Please contact SPECTRA’s Service Department for questions/comments, warranty, support, or...
- Page 6 You must pay all shipping charges required to ship the product to SPECTRA for warranty service. If the product is repaired or replaced under warranty, the return charges will be at SPECTRA’s expense. There are no other express warranties other than those stated herein.