Solid-State Drive - HP Spectre x360 Maintenance And Service Manual

Solid-state drive

Solid-state drive spare part kits include replacement rubber feet.
Description
2-TB, PCIe solid-state drive (for use in models with 8th generation Intel Core processors)
1-TB, PCIe solid-state drive
512-GB, PCIe solid-state drive
360-GB, PCIe solid-state drive
256-GB, PCIe solid-state drive
IMPORTANT:
board cable.
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
CAUTION:
the system board before removing the solid-state drive. You do not need to remove the battery to
remove the solid-state drive.
6. Remove the power connector and USB/audio board cable (see
on page
Remove the solid-state drive:
1. Remove the PM2.0×2.9 screw (1) that secures the solid-state drive to the bottom cover. (The solid-state
drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
To remove the solid-state drive, you have to remove the power connector and USB/audio
Bottom cover on page
To prevent damage to internal components, be sure to disconnect the battery cable from
36).
22).
Battery on page 23).
USB/audio/power connector board
Spare part number
941661-001
913015-001
913014-001
920299-001
913013-001
Solid-state drive 39