HP Spectre x360 Maintenance And Service Manual page 32

2. Pry around the edges of the memory cover, and then lift if off the system board (2).
3. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The edge of the module opposite the slot rises away from the computer.)
4. Remove the memory module (2) by pulling the module away from the slot at an angle.
NOTE:
Memory modules are designed with a notch to prevent incorrect insertion into the memory module slot.
Reverse this procedure to install a memory module.
26 Chapter 5 Removal and replacement procedures
The memory modules are installed upside down.