Avaya Sun Fire V880 Installation & Maintenance page 87

14. Insert the first HSI/P card into slot 3 on the I/O board. Make sure that the card is fully
seated. See the following figure.
15. Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps
into place.
16. If installing a second HSI/P card in slot 4, repeat Steps 12 through 15.
17. Remove the ESD wrist strap.
18. Close the left door.
19. Attach the HSI/P quad cables, and connect the switch links to the quad cables by
following the instructions described in Avaya Call Management System Switch
Connections, Administration, and Troubleshooting.
20. Turn on any external SCSI devices, starting with the device that is farthest from the
system and working toward the system.
21. Turn on the system monitor.
22. Turn on the system. Do not put the keyswitch in the locked position.
As the system powers up, the power LED on the monitor flashes.
23. Press Stop+A simultaneously as soon as the monitor power LED lights steadily and
the Sun logo is displayed on the monitor.
The ok prompt is displayed.
Maintaining PCI cards
Issue 2.0 June 2004 87