Avaya Sun Fire V880 Installation & Maintenance page 110

Maintenance
13. Holding the drive by its handle, fit the drive into the guide rails at the top and bottom of
the drive bay. See the following figure.
14. Slide the drive into the bay until it barely contacts the backplane.
15. Press carefully on the center of the drive. The drive handle begins to close as the drive
engages its backplane connector.
16. Press the handle toward the drive until the latch closes, securing the drive in place.
17. Repeat this procedure for both boot disk drives.
18. Close the front door and, if necessary, lock it.
19. Turn on any external SCSI devices, starting with the device that is farthest from the
system and working toward the system.
20. Turn on the system monitor.
21. Turn on the system. Do not put the keyswitch in the locked position.
As the system powers up, the power LED on the monitor flashes.
22. Press Stop+A simultaneously as soon as the monitor power LED lights steadily and
the Sun logo is displayed on the monitor.
The ok prompt is displayed.
110 Avaya CMS Sun Fire V880 Computer Hardware Installation, Maintenance, and Troubleshooting