Avaya Sun Fire V880 Installation & Maintenance page 129

8. Remove the two screws securing the front cover to the front of the system. See the
following figure.
9. Remove the front cover.
10. Disconnect the data and power cables from the back of the drive.
11. Remove the two screws that secure the drive to the chassis.
12. Slide the drive out through the front of the chassis.
13. Set the SCSI address on the new drive using the jumpers on the back of the drive. Set
the tape drive to 5. See the following figure.
14. Slide the replacement drive into the chassis and secure it with the screws that you
removed earlier.
DAT 72
TP NC 8 4 2 1
Maintaining tape drives
DDS-4
8 4 2 1
tape_jumpers.cdr
Issue 2.0 June 2004 129