Installing The Xvr-100 Software Packages - Avaya Sun Fire V880 Installation & Maintenance

Installing the XVR-100 software packages

The XVR-100 software packages must be installed after you install a new XVR-100
graphics accelerator card. If you are replacing an existing XVR-100 graphics accelerator
card, you do not have to reinstall this software.
To install the XVR-100 software packages on a Sun Fire V880 system:
1. Verify that your CMS system is running CMS R3V11 by entering:
pkginfo -x cms
Note:
Note:
2. Verify that the XVR-100 graphics accelerator card is installed.
Note:
Note:
3. Load the CD-ROM, Sun XVR-100 FCS into the CD-ROM drive.
4. Enter:
cd /cdrom/cdrom0
5. Enter:
./install
The system installs the SUNWpfbx.u, SUNWpfbcf, SUNWpfbw, and SUNWpfbmn
packages.
6. Enter:
/usr/sbin/shutdown -y -i0 -g0
The system shuts down and displays the ok prompt.
7. Enter:
boot -r
8. Log into the system as root.
The system reboots and displays the # prompt.
9. Enter:
eject cdrom
Do not perform this procedure if your CMS system is running a later load of
CMS. The software packages were installed with the Solaris operating
system.
For information on how to install the XVR-100 graphics accelerator card, see
the Sun documentation that was shipped with the card.
Maintaining PCI cards
Issue 2.0 June 2004 75