• The IP Installer Settings section located in the KVM's Web Management Interface network page must be enabled in order to use the IP Installer to assign an

IP address. This setting is enabled by default.

• The local console OSD only configures IPv4 network settings. For IPv6, access the Web Management Interface.

1. Save the IP Installer.exe file from the CD to a desired location on a computer that is on the same network as the KVM switch.

2. Locate the recently saved IP Installer.exe file and double-click on its icon. A screen similar to the one below will appear.

3. The IP Installer searches the network and displays all B030-008-19-IP KVM switches found in the device list. If your device does not

appear in the list, click the Enumerate button to refresh the device list. If more than one of the same KVM switch models appears in the

list, locate the desired device using the MAC address found on the bottom of the console KVM. Once your device is located in the list,

highlight it.

4. From here you can choose between the following two options: 1. Obtain an IP address automatically (DHCP), or 2. Specify an IP address.

If you choose to assign your own address, fill in the IP Address, Subnet Mask, and Gateway fields with information appropriate to your

network. Click on the Set IP button to apply the new network settings to the selected KVM switch.

5. After the new IP address shows up in the device list, click the Exit button to exit the IP Installer.

7.6.3 Browser

By default, the KVM switch will have an IP Address automatically assigned via DHCP server. If the KVM Switch is on a network that does not

have a DHCP server to automatically assign an IP address, it boots with a default IP address. The default IPv4 and IPv6 addresses can be

found on the sticker located on the bottom of the KVM.

1. For a computer/server on the same network as your console KVM switch, set the computer/server's IP address to 192.168.0.XXX, where

XXX represents any number or numbers except the KVM's default address.

2. Using this computer/server, access the KVM switch via the default address. A screen will appear asking to provide a username and

password.

Note: If first prompted by a screen stating the website's security certificate cannot be trusted, click on the link to proceed anyway; the certificate can be

trusted.

Table of Contents