Installing The Braking Module In A Power Module Frame Size Hx - Siemens SINAMICS G130 Operating Instructions Manual

3.3.3

Installing the Braking Module in a Power Module frame size HX

Figure 3-8
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the figures in the
diagram.
1. Insert the Braking Module.
2. Screw in the 4 retaining screws for securing the Braking Module.
3. Secure the connection clip to the DC link (DCPA / DCNA) with 2 screws (Braking Module
CAUTION
You must observe the tightening torques. Information on this can be found in the table in
the "Mechanical installation" section
Braking Module / braking resistor
Operating Instructions, 03/2012, A5E00331454A
Installing the Braking Module in a Power Module frame size HX
connection) and 2 nuts (DC link connection).
Mechanical installation
3.3 Installing the Braking Module
23