Siemens SINAMICS G130 Operating Instructions Manual page 23

Figure 3-7
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the figures in the
diagrams.
1. Unscrew the 2 M6 screws from the front cover and lift off the cover.
2. Unscrew the 4 screws from the upper cover plate.
3. Unscrew the 4 screws from the upper cover plate.
4. Unscrew the 3 screws for the blanking plate and remove the plate.
Braking Module / braking resistor
Operating Instructions, 03/2012, A5E00331454A
Installing the Braking Module in a Power Module frame size GX – steps 4 - 6
Unscrew the 1 x M6 nut on the left-hand side and remove the front cover.
Unscrew the 3 screws from the rear cut-out sections and remove the rear cover.
Mechanical installation
3.3 Installing the Braking Module
21