Table of Contents
Advertisement
Mops chemo-thermal dis-
infection + finish*****
Type of fabric
Program cycle
Mops finish
Type of fabric
Program cycle
* The Cooldown block can be activated if required, e.g. for gently cooling down microfiber mops.
** Program locked. If a program is locked, after 1 minute it can no longer be stopped and cancelled with the finish button.
*** The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time, and dosages)
must be set on site to suit cleaning agents and disinfectants.
Information on Mops...+ finish program
The Mops . . . + finish programs prepare mops for use by treating them with cleaning
agent or disinfectant: a finishing step with a final spin is added after the washing or disin-
fecting stage.
Amounts dispensed must be set on site and the standard of disinfection must be checked.
Information on Mops finish program
The Mops finish program is suitable for clean and dry mops. A disinfectant solution is
added during finishing.
Amounts dispensed must be set on site and the standard of disinfection must be checked.
140 °F (60 °C)
Cotton, viscose, polyester and microfiber mops
Program as for Mops chemo-thermal disinfec-
tion*, then:
Finishing agent, damp
or activate block:
Damp, wet, dripping wet
Cotton, viscose, polyester and microfiber mops
1 rinse
Finishing agent, damp
or activate block:
Damp, wet, dripping wet
Program chart - MOPSTAR
Load ratio/Load
size
1:10
PW 413 - 28 lb
(13 kg)
PW 418 - 39 lb
(18 kg)
For number,
see
"Mops per load"
table
39
Advertisement
Table of Contents
