Table of Contents
Advertisement
Optional modules
Avoiding block-
ages and corro-
sion in the dis-
pensing system
To go directly to
Dispenser calibra-
tion when the ma-
chine is switched
off:
60
Dispensing quantities
Please follow the detergent manufacturer's instructions.
Always follow the instructions of the chemical manufacturer when
using cleaning agents and special application chemicals. Only use
such chemicals for the purpose and in the situation specified by
the manufacturer in order to avoid the danger of adverse chemical
reactions and material damage.
Correct dosage also depends on the viscosity of the liquid detergent.
It should therefore be allowed to settle to room temperature before
being used.
Cleaning and maintenance of the dispensing system
Rinse out the siphons with water.
Put the siphons in a container with warm water (104 - 122 °F / 40 -
50 °C).
Activate the dispenser calibration switch in each pump, until the
dispensing system is rinsed through.
Check the connections, hoses, dispensing sockets and seals for
leaks.
Rinse the dispensing system with hot water every 2 weeks, or before
shutting the dispenser pumps down for any length of time, to avoid
the system getting clogged up and corroded.
Commissioning the dispenser pumps
Before the liquid dispenser pumps can be used the liquid detergent
must be drawn into the system and the set amount to be dispensed.
Dispenser calibration
Dispenser calibration is used to measure the throughput of individual
dispenser pumps.
Press and hold multifunction button 2 and switch the machine on
using Power On .
Dispensing calibration
Dispensing pump 1
Dispensing pump 2
Options:
– Dispenser pump 1 to 13
Select a dispenser pump.
When a dispenser pump is selected, the following will appear in the
display:
Main menu
Advertisement
Table of Contents
