Information On Mops; Information On Finish Mops Programme - Miele PW 413 Operating And Installation Instructions

Mops chemo-thermal dis-
infection + finish*****
Material
Programme se-
quence
Finish mops
Material
Programme se-
quence
* The Cooldown block can be activated if required, e.g. for gently cooling down microfibre mops.
** Programme locked. If a programme is locked, after 1 minute it can no longer be stopped and cancelled with the finish
button.
*** The disinfection parameters for chemo-thermal disinfection (temperature, temperature holding time, and dosages)
must be set on site to suit cleaning agents and disinfectants.
Information on Mops...+ finish programme
With the Mops . . . + finish programme the mops are ready to use and already impreg-
nated with cleaning agent and disinfectant. To achieve this, following washing or disinfec-
tion there is a finishing stage and then a final spin.
Dosage amounts must be set on site and the standard of disinfection must be checked.

Information on Finish mops programme

The Finish mops programme is suitable for the subsequent finishing of clean and dry
mops. A disinfecting agent is applied during finishing.
Dosage amounts must be set on site and the standard of disinfection must be checked.
60 °C
Cotton, viscose, polyester and microfibre mops
Programme sequence as for Mops thermal disin-
fection, then:
Finishing agent, damp
or activate block:
Damp, wet, dripping wet
Cotton, viscose, polyester and microfibre mops
1 rinse
Finishing agent, damp
or activate block:
Damp, wet, dripping wet
Programme chart - MOPSTAR
Fill ratio/Load
size
1:10
PW 413 - 13 kg
PW 418- 18 kg
For number,
see
"Mops per load"
chart
41