Table of Contents
Advertisement
Method A:
1. Press the wall-mount lever, and pull the phone away from the stand,
as shown in
Figure 13 on page
2. Use the stand cover (the part you removed in
cover" on page
bottom of the stand cover firmly against the wall in the location where
you wish to install the phone. Four small pins on the bottom of the
stand cover make marks on the wall.
3. Use the marks as a guideline for installing the wall-mount screws (not
provided). Install the screws so that they protrude 3 millimeters (mm)
(1/8 inch) from the wall.
4. Install the phone stand mounting holes over the screw heads as
indicated in
Figure 12 on page 62
the phone from the wall to adjust the lower screws.
5. When the lower screws are snug, install the phone on the mounting
screws, and then tighten the top screws.
Figure 13: Rotate the phone into the wall mount position.
Using your Avaya 1165E IP Deskphone
63.
57), to mark the wall-mount holes by pressing the
Tilt lever
"Removing the stand
(Method A). You need to remove
Wall-mount lever
63
Advertisement
Table of Contents
