Replace Front Panel; Front Panel Options; Equipment Required; Replacement Procedure - Honeywell Thor VM3 User Manual

Replace Front Panel

Front Panel Options

The front panel of the Thor VM3 is field replaceable. The front panel assembly contains
the keypad, touch screen and optional defroster. Should any of these components fail,
the front panel assembly can easily be replaced to reduce downtime. The replacement
front panel is available in these configurations:
•
•
•
•
•
Note: The resistive and PCAP touch screens each use a unique stylus. If switching between
touch screen types, be sure to swap the stylus as well.

Equipment Required

The following equipment is user-supplied:
•
•

Replacement Procedure

Caution: Before replacing the Thor VM3 front panel,
1. Place the Thor VM3 on a clean, well-lit
2. Shutdown the Thor VM3.
3. Remove the Thor VM3 from the dock.
4.
5. Loosen the sixteen (16) captive M3
Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
Standard temperature with resistive touch screen
Cold storage with resistive touch screen
Standard temperature with PCAP touch screen
Outdoor with resistive touch screen
Outdoor with PCAP touch screen
Torquing tool capable of measuring inch pounds
#2 Phillips screwdriver bit
Battery.
surface before performing the front panel
replacement.
Disconnect UPS Battery.
screws holding the front panel. Use a #2
Phillips bit.
Disconnect UPS
1 5 9
11
16
14
3 8 10
7 4
13
15
12
6 2
129