Keypad Backlight; Speaker Volume; Power Up - Honeywell Thor VM3 User Manual

Keypad Backlight

By default, the integrated keypad backlight follows the display backlight. The integrated
keypad backlight can be disabled.
To change this behavior, see the
The external USB keyboard backlight is manually controlled.

Speaker Volume

The speaker volume can be adjusted via the Thor VM3 keypad:
1. Press the Blue key to enter Blue mode
2. Press the P1 key to increase speaker volume or the P2 key to decrease speaker
3. Press the Blue key to exit Blue mode.
The current volume level can be viewed on the
tray speaker icon. These items can also be used to adjust speaker volume.

Power Up

If a USB drive, such as a thumb drive is attached to the Thor VM3, the device
may attempt to boot from the USB drive. Remove the USB drive and power
up the Thor VM3 again.
The dock has a power switch on the back.
The "On" side of this rocker switch has a raised bump to allow the state of the switch to
be determined when the switch may not be easily viewed, for example, after the dock is
mounted in a vehicle.
After external power has been connected and the Thor VM3 has been mounted in the
dock, press the side of the power switch with the raised bump to pass power from the
dock to the Thor VM3.
Next locate the power button on the front of the Thor VM3.
20 Thor VM3 with Microsoft Windows 7 or Windows Embedded Standard 7 User Guide
volume.
Standard Dock
Options control panel.
Sounds control panel or via the system
Enhanced Dock