2.2
LED Identification
This section provides an overview of the front and rear LEDs.
2.2.1 Front LEDs
LED
Description
•
•
System LED
•
•
•
•
•
When NOS is running:
•
Power LED
•
•
•
Fan LED
•
•
Locator LED
•
•
•
10G SFP+ slots
•
(Two LEDs per
•
port)
•
QSFP+ Port LED
Upper SFP+ Port LED
(Figure 2-3: Front LED Identification)
Off – Power is off
Solid Green – Normal operation
Blinking Green – Booting in progress
Solid Yellow – Major Fault and the faults are Traffic Affecting
Blinking Yellow – Minor Fault and Non-Traffic Affecting
Solid Green – Booting
Off – Power is disconnected
Solid Green – 2 Power Supplies are supplied to the switch and operating
normally
Solid Yellow – Single power supply is installed and operating
Blinking Yellow – 2 Power Supplies are installed, but only single power
supply is operating
Solid Green – FAN operating normally
Solid Yellow – FAN is failed including incompatible airflow direction
Off – LED is turned off
Blinking Green – The locator function is enabled
Solid Green – The locator function is disabled
Off – No link
Solid Green – A valid 10Gbps link
Solid Yellow – A valid 1G link
Blinking Green – Packet transmission or reception in progress
Chapter 2
Power LED
System LED
Locator LED
Fan LED
Lower SFP+ Port LED
4
•
Appearance and Mechanism