Horizontal Surface Mounting - Delta AG7648 Installation Manual

3. If installing a single switch only, go to " Connecting to a Power Source ".
4. If installing multiple switches, mount them in the rack, one below the other, in any order.

3.1.2 Horizontal Surface Mounting

The switch includes four pre-installed rubber feet for horizontal surface mounting.
To mount devices on a horizontal surface, follow these steps:
1. Attach the four adhesive feet to the bottom of the first switch.
2. Set the device on a flat horizontal surface near an AC power source, making sure there are
at least two inches of space on all sides for proper air flow.
3. If installing a single switch only, go to " Connecting to a Power Source ".
4. If installing multiple switches, attach four adhesive feet to each one, then place each device
squarely on top of the one below, in any order.
(Figure 3-2: Installing the Switch in a Rack)
(Figure 3-3: Attaching the Adhesive Feet)
10
Chapter 3 • Installation