Radyne DMD20 Installation And Operation Manual page 97

User Interfaces
LARGEST HB GAP
IF BOARD (menu)
AGC/CTRL/VALUE
I OFFSET
Q OFFSET
IF RX LVL OFFSET
LB RX LVL OFFSET
POWER SOURCE
TERR INTFC BRD
CODEC BOARD (menu)
TPC FPGA IMAGE
RS FPGA IMAGE
TPC CODEC IMAGE
FRONT PANEL BOARD
FEATURES (menu)
5012.2840.2417
UPGRADE LIST (menu) The following menu screens display the following:
4-38
Used for factory test only.
Indicates the Radyne
Assembly.
{0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
Used for factory test only.
Used for factory test only.
Used for factory test only.
Used for factory test only.
Used for factory test only.
Indicates the Radyne assembly number for the
Terrestrial Interface Assembly.
Indicates the Radyne part number for the Codec Board.
Used for factory test only.
Used for factory test only.
Used for factory test only.
Indicates the Rdyne assembly number for the front panel
board.
{____.____.____}
Allows the user to install purchased feature upgrades
(see Appendix A).
Whether or not the feature has been upgraded, or if the
feature requires a hardware upgrade (contact the
Radyne Customer Service Department).
511 KBPS, 1 MBPS, 5 MBPS, 10 MBPS, 20 MBPS (The highest option
installed will hide the lower rates.)
RXIF
RXLBAND
TXIF
TXLBAND
DMD20/DMD20 LBST Universal Satellite Modem
part number for the IF Board
TM103 - Rev. 2.5