Interface Menu Options And Parameters - Radyne DMD20 Installation And Operation Manual

DMD20/DMD20 LBST Universal Satellite Modem
RS RATE
INTERLVR DEPTH
ODU-LNB (menu)
LO FREQ (MHz)
OSC SIDE BAND
10 MHz LNB REF
VOLTAGE SELECT
LNB VOLTAGE

4.3.4 Interface Menu Options and Parameters

TX SETUP (menu)
CIRCUIT ID
TERR INTERFACE
ETH FLOW CONTROL
TM103 – Rev. 2.5
{Refer to Table 3-1 for valid n/k values}
Displays the currently used n, k Reed-Solomon Codes.
In Closed Net Mode, the user may select custom R-S
Codes.
{4, 8, 12}
Allows the user to select the Reed-Solomon interleaver
depth. In Closed Net Mode, a depth of 4 or 8 may be
selected.
Allows the user to enter the Local Oscillator frequency in
MHz in order for the downlink frequency to be displayed
correctly (refer to the LNB manufacturer's
specifications).
{LOW SIDEBAND, HIGH SIDEBAND}
Allows the user to select the location of the LNB LO.
The user must enter the location of the LNB LO in order
for the UPLINK FREQUENCY to be displayed correctly.
The LNB LO can be either higher or lower in frequency
than the LNB output frequency. If the LNB LO is higher
in frequency then the user must enter HIGH SIDEBAND.
{ENABLED, DISABLED}
Allows the user to enable or disable the 10 MHz BUC
reference clock.
{13 VDC, 15 VDC, 18 VDC, 20 VDC}
Allows the user to select the voltage required by the LNB
(refer to the LNB manufacturer's specifications).
{ENABLED, DISABLED}
Allows the user to enable or disable the LNB supply
voltage.
Allows the user entry of a Tx Circuit Identifier. Circuits
can be given up to an 11 Character alphanumeric
identity such as LINK1.
{RS422 SERIAL, M2P PARALLEL, DVB PARALLEL,
G.703 E2, G.703 T2 BAL, G.703 T2 UNBAL, G.703 E1
BAL, G.703 E1 UNBAL, G.703 T1 AMI, G.703 T1
B8ZS, V.35, HSSI, ASI, ETHERNET}
Allows the user to select the Transmit Type.
{Disabled, Enabled}
User Interfaces
4-15