Radyne DMD20 Installation And Operation Manual page 67

User Interfaces
SCRAMBLER CTRL
SAT FRAMING
When SCC Framing is selected above, the following two screens are
SCC CTL RATIO
SCC INBAND RATE
TERR FRAMING
DATA POLARITY
SYMBOL PAIR
ESC OVERHEAD
AUPC (menu)
AUPC MODE
AUPC Eb/No
AUPC MIN LVL
4-8
DMD20/DMD20 LBST Universal Satellite Modem
{ENABLED, DISABLE}
Allows the user to enable or disable scrambler operation.
{1/15 (IBS), 1/15 (Async), 96 Kbps (IDR), DVB,
EDMAC, EFAUPC, SCC, None}
Used with IDR, IBS, or Asynchronous Interface Only.
Allows the user to select the framing type.
available.
{1/1, 1/2, 1/3, 1/4, 1/5, 1/6, 1/7}
Allows the user to simulate the framing used by the
Satellite Control Channel Option (Pass Thru Mode only).
The SCC CTL RATIO is the ratio of overhead in-band
data to synchronizing words.
{300 to 200000}
Allows the user to request the rate of in-band data for
the overhead channel.
{NONE, 188, 204} DVB Only
{INV. TERR & BASE, INV. BASEBAND, INV.TERR
DATA, NONE}
Allows the user to invert the Tx Data polarity.
{NONE, SWAPPED}
Allows the user to swap the I & Q Channels.
(BPSK Mode Only)
{VOICE X2, DATA 64KBPS}
IDR ESC Channel used for Voice or 64 K data channel.
Displays when IBS Framing is selected for the Modulator
and Demodulator.
{DISABLED, RADYNE}
Displays the AUPC Mode.
Allows the user to enter the target Eb/No value.
{variable through power range}
Allows the user to set the minimum Transmit Power.
The minimum Transmit Power is the lowest power
setting that will be used when the remote modem
commands a decrease of the Transmit Power.
TM103 - Rev. 2.5