Radyne DMD20 Installation And Operation Manual page 82

Universal
Table of Contents

Advertisement

DMD20/DMD20 LBST Universal Satellite Modem
LINK STATUS (menu)
The status of the following ports may be one of the following:
Down:
Unresolved:
10 Mbps Half:
10 Mbps Full:
100 Mbps Half:
100 Mbps Full:
PORT 1 STATUS
PORT 2 STATUS
PORT 3 STATUS
PORT 4 STATUS
WAN STATUS
FREQ OFFSET (Hz)
VOLTAGES (menu)
+1.5V RX SUPPLY
+1.5V TX SUPPLY
+3.3V SUPPLY
+5V SUPPLY
+12V SUPPLY
TM103 – Rev. 2.5
(the following sub-menus only display when
Ethernet is selected as the interface type)
The link is down.
Unable to agree on connection speed.
Connected at 10 Base-T Half Duplex.
Connected at 10 Base-T Full Duplex.
Connected at 100 Base-T Half Duplex.
Connected at 100 Base-T Full Duplex.
{See the note above}
Displays the current status of LAN Port 1.
{See the note above}
Displays the current status of LAN Port 2.
{See the note above}
Displays the current status of LAN Port 3.
{See the note above}
Displays the current status of LAN Port 4.
{See the note above}
Displays the current status of the WAN Port.
Displays the received carrier frequency offset as
measured by the modem.
Displays the measured voltage of the 1.5 Volt Rx power
bus located inside the modem.
Displays the measured voltage of the 1.5 Volt Tx power
bus located inside the modem.
Displays the measured voltage of the +3.3 Volt power
bus located inside the modem.
Displays the measured voltage of the +5 Volt power bus
located inside the modem.
Displays the measured voltage of the +12 Volt power
bus located inside the modem.
User Interfaces
4-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dmd20 lbst

Table of Contents