Radyne DMD20 Installation And Operation Manual page 94

DMD20/DMD20 LBST Universal Satellite Modem
To change the display for the IP ADDRESS MASK, MODEM IP ADDRESS,
SERVER IP ADDRESS, AND ROUTER IP ADDRESS, press all four arrow
keys simultaneously.
MODEM EADDR
ETHER RATE
SNMP (menu)
SNMP VERSION
TM103 – Rev. 2.5
Broadcast and loop back addresses will not be allowed.
These are addresses with all subnet bits set to 0's or 1's.
{001065010000}
Displays the Ethernet address of the device. Set at the
factory and is a unique identifier for the Ethernet physical
interface.
{10 MBPS/HD}
The data rate for the local Ethernet Interface.
10 Mbps/HD – for 10 Base-T in either half-duplex or full
duplex.
A description of OID organization is provided in the MIB
portion of this manual (Appendix C).
{V1 & V2, V3}
This selection controls the SNMP Version that will be
used in messaging between the equipment and it's host.
When V1 & V2 is used, RD COMMUNITY and RDWR
COMMUNITY are used to determine the authorization of
an incoming message.
When V3 is used, three contexts are supported: public,
mib2, and dev. Context, Authentication and Privacy are
a portion of each SNMPV3 message.
The public context will only allow the user to see the
sysoid of the unit. This is the most restricted access
possible and only allows the unit to be identified by a
host SNMP Station.
The mib2 context allows a user with appropriate
authentication to access the mib2 OIDs and the SNMP
OIDs. These are of interest primarily to network
operators not controlling the satellite link.
The dev context allows a user with appropriate
authentication to access the device control portion of the
MIB. These OIDs are used to control the devices
satellite link and operation.
User Interfaces
4-35