Radyne DMD20 Installation And Operation Manual page 87

User Interfaces
LNB CURRENT
LNB VOLTAGE
COMMON (menu)
TERR FPGA CFG
CODEC FPGA CFG
CODEC DEV CFG
VOLTAGES (menu)
+1.5V RX SUPPLY {Pass/Fail, Unmasked/Masked}
+1.5V TX SUPPLY {Pass/Fail, Unmasked/Masked}
+3.3V SUPPLY
+5V SUPPLY
+12V SUPPLY
+20V SUPPLY
-12V SUPPLY
4-28
DMD20/DMD20 LBST Universal Satellite Modem
{Pass/Fail, Unmasked/Masked}
Indicates that current is either below or above the
threshold limits of the BUC, as specified by the modem.
Only active when voltage is enabled.
{Pass/Fail, Unmasked/Masked}
Indicates that voltage is not functioning correctly when
voltage is enabled.
{Pass/Fail, Unmasked/Masked}
Indicates an Interface Card FPGA configuration failure.
{Pass/Fail, Unmasked/Masked}
Indicates Turbo Codec Card FPGA configuration failure.
{Pass/Fail, Unmasked/Masked}
Indicates Turbo Codec Card ASIC configuration failure.
Displays the measured voltage of the 1.5 Volt Rx power
bus located inside the modem.
Displays the measured voltage of the 1.5 Volt Tx power
bus located inside the modem.
{Pass/Fail, Unmasked/Masked}
Displays the measured voltage of the +3.3 Volt power
bus located inside the modem.
{Pass/Fail, Unmasked/Masked}
Displays the measured voltage of the +5 Volt power bus
located inside the modem.
{Pass/Fail, Unmasked/Masked}
Displays the measured voltage of the +12 Volt power
bus located inside the modem.
{Pass/Fail, Unmasked/Masked}
Displays the measured voltage of the +20 Volt power
bus located inside the modem.
{Pass/Fail, Unmasked/Masked}
Displays the measured voltage of the -20 Volt power bus
located inside the modem.
TM103 - Rev. 2.5