Intended Use - SCHNIER smart-E 310 Operating Manual

3.

Intended Use

These devices are intended for use in stationary electrostatic application equipment for
coating to product standards:
EN 50176:2009 Stationary electrostatic application equipment for ignitable liq-
uid coating material
EN 50177:2009 Stationary electrostatic application equipment for ignitable coat-
ing powders
EN 50223:2015 Stationary electrostatic application equipment for ignitable flock
material
EN 50348:2010 + Cor:2010 Stationary electrostatic application equipment for
nonignitable liquid coating material
This high-voltage generator is a device of category 2G or 2D for use in potentially ex-
plosive areas of Zone 1 or 21. The high-voltage generator must only be used in poten-
tially explosive atmospheres, which are themselves generated through the spray cloud
of the processed coating material.
CAUTION
The respective type of electrostatic spraying equipment is to be deter-
mined on the basis of their EU-Type Examination Certificate in assembly
with the high-voltage control "smart-E".
CAUTION
It is to ensure by inspection prior to commissioning and periodic testing
that the values of the output current and the output voltage of the electro-
static spraying equipment referred in the EU-Type Examination Certifi-
cate are not exceeded.
CAUTION
It is to ensure by inspection prior to commissioning and periodic testing
that the requirements of 5.3.1, 6.3.3.2, 6.3.4.2, 6.3.5, 6.3.6 and 6.4 of EN
50176:2009 respectively the relevant requirements of EN 50177:2009,
EN 50223:2010 or EN 50348:2010 are fulfilled.
CAUTION
Every start up outside of this regulation is prohibited.
CAUTION
The device may not be changed.
Operation, installation and service work must only be performed by suffi-
ciently trained personnel.
This device must not be used alone. It may only be put into operation after complete
and proper installation and if it is detected that the system in which the device will be
installed corresponds totally to the regulations of the above mentioned product stand-
ards. The details of this operating manual must be complied with.
Operating manual 810378-BAL-EN-170330 Mach/30 2017 Page 9 of 54