Description Of The Status Word - SCHNIER smart-E 310 Operating Manual

11.2.6.
Byte Bit Status bit
0 0 HV display ON
1 Reserve
2 Collective error / switch off
3 Collective warning
4 The high voltage is safety off.
CAUTION:
This SW bit does not fulfill the Per-
formance Level, this is only
achieved by HW feedback.
5 Reserve
6 Drive power status
7 Monitoring contact status
1 0 Heartbeat
1 Reserve
2 Reserve
3 Reserve
4 Warning: invalid parameters
5 Imax warning
6 Reserve
7 Reserve
Operating manual 810378-BAL-EN-170330

Description of the status word

Mach/30 2017
Description
Mirror bit of the HV EIN bit
higher)
1: For error or switch off
0: no error
1: For warning
0: No warning
1: If the high voltage has been
switched off and the output voltage
has discharged to a safe level.
0: If the high voltage is switched on /
or the output voltage has not been
discharged to a safe level
0: If a self-test error of the device has
been detected
1: 24 V DRIVE is on
0: 24 V DRIVE is not on
1: Relay contact open
0: Relay contact closed
This Bit is switched every second
between 1 (logic high) and 0 (logic
low) to display that the HV-supply is
still active.
1: An invalid parameter (value
outside of range) has been received.
0: parameter valid
1: I actual is above 80 % of Imax
0: I actual is below 80 % of Imax
(V2.01 and
Page 51 of 54