Manual Voice Vlan Assignment Mode Configuration Example - HPE FlexFabric 5940 Series Configuration Manual

Voice VLAN enabled ports and their modes:
Port
XGE1/0/1
XGE1/0/2

Manual voice VLAN assignment mode configuration example

Network requirements
As shown in
To enable Ten-GigabitEthernet 1/0/1 to transmit only voice packets, perform the following tasks on
Device A:
•
Create VLAN 2. This VLAN will be used as a voice VLAN.
•
Configure Ten-GigabitEthernet 1/0/1 to operate in manual voice VLAN assignment mode and
add it to VLAN 2.
•
Add the OUI address of IP phone A to the OUI list of Device A.
Figure 67 Network diagram
Configuration procedure
# Enable security mode for voice VLANs.
<DeviceA> system-view
[DeviceA] voice-vlan security enable
# Add MAC address 0011-2200-0001 with mask FFFF-FF00-0000.
[DeviceA] voice-vlan mac-address 0011-2200-0001 mask ffff-ff00-0000 description test
# Create VLAN 2.
[DeviceA] vlan 2
[DeviceA-vlan2] quit
# Configure Ten-GigabitEthernet 1/0/1 to operate in manual voice VLAN assignment mode.
[DeviceA] interface ten-gigabitethernet 1/0/1
[DeviceA-Ten-GigabitEthernet1/0/1] undo voice-vlan mode auto
# Configure Ten-GigabitEthernet 1/0/1 as a hybrid port.
[DeviceA-Ten-GigabitEthernet1/0/1] port link-type hybrid
# Set the PVID of Ten-GigabitEthernet 1/0/1 to VLAN 2.
[DeviceA-Ten-GigabitEthernet1/0/1] port hybrid pvid vlan 2
# Assign Ten-GigabitEthernet 1/0/1 to VLAN 2 as an untagged VLAN member.
[DeviceA-Ten-GigabitEthernet1/0/1] port hybrid vlan 2 untagged
VLAN
2
3
Figure 67, IP phone A send untagged voice traffic.
Mode CoS
Auto 6
Auto 6
204
DSCP
46
46