Step
Configure the advertisable
3.
TLVs (in Layer 2 Ethernet
interface view).
Command
•
lldp tlv-enable { basic-tlv { all |
port-description |
system-capability |
system-description |
system-name |
management-address-tlv
[ ipv6 ] [ ip-address ] } | dot1-tlv
{ all | congestion-notification |
port-vlan-id | link-aggregation
| protocol-vlan-id [ vlan-id ] |
vlan-name [ vlan-id ] |
management-vid [ mvlan-id ] } |
dot3-tlv { all | mac-physic |
max-frame-size | power } |
med-tlv { all | capability |
inventory | network-policy
[ vlan-id ] |
power-over-ethernet |
location-id { civic-address
device-type country-code
{ ca-type ca-value }&<1-10> |
elin-address tel-number } } }
•
lldp agent nearest-nontpmr
tlv-enable { basic-tlv { all |
port-description |
system-capability |
system-description |
system-name |
management-address-tlv
[ ipv6 ] [ ip-address ] } | dot1-tlv
{ all | congestion-notification |
port-vlan-id |
link-aggregation } }
•
lldp agent nearest-customer
tlv-enable { basic-tlv { all |
port-description |
system-capability |
system-description |
system-name |
management-address-tlv
[ ipv6 ] [ ip-address ] } | dot1-tlv
{ all | congestion-notification |
port-vlan-id |
link-aggregation } }
264
Remarks
By default:
•
Nearest bridge agents can
advertise all LLDP TLVs
except the location
identification, port and
protocol VLAN ID, VLAN
name, and management
VLAN ID TLVs.
•
Nearest non-TPMR bridge
agents do not advertise
TLVs.
•
Nearest customer bridge
agents can advertise basic
TLVs and IEEE 802.1
organizationally specific
TLVs.