Step
Enter aggregate
2.
interface or subinterface
view.
Configure the
3.
description of the
aggregate interface or
subinterface.
Setting the MAC address for an aggregate interface
By default, all aggregate interfaces on a device use the same MAC address, and aggregate
interfaces on different devices use different MAC addresses. Typically, the MAC address of an
aggregate interface is not required to be modified.
Do not set MAC addresses for aggregate interfaces on border gateways in VXLAN or EVPN
networks.
To set the MAC address for an aggregate interface:
Step
Enter system view.
1.
Enter Layer 3 aggregate
2.
interface or subinterface
view.
Set the MAC address for the
3.
aggregate interface or
subinterface.
Specifying ignored VLANs for a Layer 2 aggregate interface
The system ignores the permit state and tagging mode of an ignored VLAN when choosing Selected
ports.
By default, to become Selected, the member ports must have the same VLAN permit state and
tagging mode as the corresponding Layer 2 aggregate interface.
To specify ignored VLANs for a Layer 2 aggregate interface:
Step
Enter system view.
1.
Enter Layer 2 aggregate
2.
interface view.
Specify ignored VLANs.
3.
Command
•
Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface or subinterface view:
interface route-aggregation
{ interface-number |
interface-number.subnumber }
description text
Command
system-view
interface route-aggregation
{ interface-number |
interface-number.subnumber }
mac-address mac-address
Command
system-view
interface bridge-aggregation
interface-number
link-aggregation ignore vlan
vlan-id-list
53
Remarks
N/A
By default, the description of an
interface is interface-name
Interface.
Remarks
N/A
N/A
By default, the MAC address of a
Layer 3 aggregate interface or
subinterface is not set.
Remarks
N/A
N/A
By default, a Layer 2 aggregate
interface does not ignore any
VLANs.