Setting The Lldp Reinitialization Delay; Enabling Lldp Polling - HPE FlexFabric 5940 Series Configuration Manual

Step
Enter Layer 2/Layer 3
2.
Ethernet interface view,
management Ethernet
interface view, Layer
2/Layer 3 aggregate
interface view, or IRF
physical interface view.
Set the LLDP operating
3.
mode.

Setting the LLDP reinitialization delay

When the LLDP operating mode changes on a port, the port initializes the protocol state machines
after an LLDP reinitialization delay. By adjusting the delay, you can avoid frequent initializations
caused by frequent changes to the LLDP operating mode on a port.
To set the LLDP reinitialization delay for ports:
Step
Enter system view.
1.
Set the LLDP reinitialization
2.
delay.

Enabling LLDP polling

With LLDP polling enabled, a device periodically searches for local configuration changes. When the
device detects a configuration change, it sends LLDP frames to inform neighboring devices of the
change.
To enable LLDP polling:
Step
Enter system view.
1.
Command
interface interface-type
interface-number
•
In Layer 2/Layer 3 Ethernet
interface view or management
Ethernet interface view:
lldp [ agent { nearest-customer
| nearest-nontpmr } ]
admin-status { disable | rx | tx |
txrx }
•
In Layer 2/Layer 3 aggregate
interface view:
lldp agent { nearest-customer |
nearest-nontpmr }
admin-status { disable | rx | tx |
txrx }
•
In IRF physical interface view:
lldp admin-status { disable | rx |
tx | txrx }
Command
system-view
lldp timer reinit-delay delay
Command
system-view
262
Remarks
N/A
By default:
•
The nearest bridge agent
operates in txrx mode.
•
The nearest customer
bridge agent and nearest
non-TPMR bridge agent
operate in disable mode.
In Ethernet interface view, if you
do not specify an agent type, the
command sets the operating
mode for nearest bridge agents.
In aggregate interface view, you
can set the operating mode only
for nearest customer bridge
agents and nearest non-TPMR
bridge agents.
In IRF physical interface view,
you can set the operating mode
only for nearest bridge agents.
Remarks
N/A
The default setting is 2 seconds.
Remarks
N/A