Configuring An Inloopback Interface; Displaying And Maintaining Loopback, Null, And Inloopback Interfaces - HPE FlexFabric 5940 Series Configuration Manual

applying an ACL. For example, if you specify a null interface as the next hop of a static route to a
network segment, any packets routed to the network segment are dropped.
To configure a null interface:
Step
Enter system view.
1.
Enter null interface view.
2.
Configure the interface
3.
description.
Restore the default settings
4.
for the null interface.

Configuring an inloopback interface

An inloopback interface is a virtual interface created by the system, which cannot be configured or
deleted. The physical layer and link layer protocol states of an inloopback interface are always up. All
IP packets sent to an inloopback interface are considered packets sent to the device itself and are
not forwarded.
Displaying and maintaining loopback, null, and
inloopback interfaces
Execute display commands in any view and reset commands in user view.
Task
Display information about the specified or all
loopback interfaces.
Display information about the null interface.
Display information about the inloopback
interface.
Clear the statistics on the specified or all loopback
interfaces.
Clear the statistics on the null interface.
Command
system-view
interface null 0
description text
default
Command
display interface loopback [ interface-number ] [ brief
[ description | down ] ]
display interface null [ 0 ] [ brief [ description |
down ] ]
display interface inloopback [ 0 ] [ brief [ description
| down ] ]
reset counters interface loopback
[ interface-number ]
reset counters interface null [ 0 ]
19
Remarks
N/A
Interface Null 0 is the default null
interface on the device and cannot
be manually created or removed.
Only one null interface, Null 0, is
supported on the device. The null
interface number is always 0.
The default setting is NULL0
Interface.
N/A