HPE FlexFabric 5940 Series Configuration Manual page 253

Step
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
Set the link type of the port.
3.
Assign the port to the original
4.
VLANs and the translated
VLANs.
Configure a many-to-one
5.
VLAN mapping.
Configuring the network-side port
Step
Enter system view.
1.
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
Set the link type of the port.
3.
Assign the port to the
4.
translated VLANs.
Configure the port to use the
5.
original VLAN tags of the
many-to-one mapping to
replace the VLAN tags of the
packets destined for the user
network.
Command
•
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Set the port link type to trunk:
port link-type trunk
•
Set the port link type to
hybrid:
port link-type hybrid
•
For the trunk port:
port trunk permit vlan
vlan-id-list
•
For the hybrid port:
port hybrid vlan vlan-id-list
tagged
vlan mapping uni { range
vlan-range-list | single
vlan-id-list } translated-vlan
vlan-id
Command
system-view
•
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Set the port link type to trunk:
port link-type trunk
•
Set the port link type to
hybrid:
port link-type hybrid
•
For the trunk port:
port trunk permit vlan
vlan-id-list
•
For the hybrid port:
port hybrid vlan vlan-id-list
tagged
vlan mapping nni
243
Remarks
N/A
By default, the link type of a port is
access.
N/A
By default, no VLAN mapping is
configured on an interface.
Remarks
N/A
N/A
By default, the link type of a port is
access.
N/A
By default, the port does not
replace the VLAN tags of the
packets destined for the user
network.