Using Manual Finishing - Sharp MX-M850 User Manual

USING MANUAL FINISHING

The procedure for using manual finishing is explained below. Before beginning the procedure, configure the paper
settings in the system settings for the paper you will load in the inserter.
☞
PAPER TRAY SETTINGS
COPY IMAGE SEND
Ready to scan for copy.
1
Exposure
Auto
Copy Ratio
100%
2
(3)
Set the output function.
3
Top Tray
Offset Tray
Staple
Press the [START] key (
Output takes place using the selected function.
When the staple or saddle stitch function is used, all sheets of paper loaded in the tray are stapled together as a single set.
4
To stop manual finishing...
Press the [STOP] key (
(page 80)
DOCUMENT MANUAL
FILING FINISHING
Plain
Plain
Plain
8½x11
5.
11x17
1. 2. 6.
8½x11 8½x11 11x17
11x17
3. 7.
8½x14 11x17
4.
Original Paper Select
Auto
Auto
8½x11
8½x11
Plain
(1)
Plain
8½x11
Plain
8½x11
Saddle
Stitch
)
).
Touch the [MANUAL FINISHING] key.
The base screen for manual finishing will appear.
0
Special Modes
2-Sided Copy
Output
File
Quick File
Load the paper to be used for finishing
in the inserter.
For the procedure for loading paper on the paper tray, see
"INSERTER" (page 62).
The orientation in which the paper is loaded on the tray will vary
depending on which manual finishing function is used. Make
sure you load the paper in the correct orientation for the
function you are using.
☞
PAPER LOADING ORIENTATION (FOR THE STAPLE
AND PUNCH FUNCTIONS)
☞
PAPER LOADING ORIENTATION (FOR FOLDING)
Select the manual finishing function.
(2)
(1) Select the paper tray on which you loaded
paper.
(2) Select the function you wish to use.
(3) Select the output tray.
Fold
2 Hole
Punch
3 Hole
Punch
66
(page 69)
(page 70)